I believe it is an issue on the firmware, but if I have overlooked something, please tell me.Review of the J4125 and N5095/N5105/N6005 hardware from AliExpress seems to have raised the profile of these little boxes, or at least created some interesting threads in the forums. I am not sure if it is just me (odd), or someone else has run into this, or someone else will run into this in the future. Until, after the reset, which cleaned out the table and router started to hand out different IP than the DHCP allowed. So, they were receiving same IP, so I had no issues because no new devices were plugged in. They all were assigned static IP via the Speedport page > Network > Connected Devices > "Always same IP Address" for each device. Something I noticed that, it didn't crash immediately after the firmware update. I had to re-do my internal network to change the devices IP and it wasted my entire day. So, this caused a huge problem/headache for my internal network because most of my internal network is static IP and it wasn't going to work with my internal router being 192.168.1.1 and Speedport also being same IP. 1.x on the Speedport, and with auto-configuration on my computer, again I had internet. I removed the manual configuration and it was back to same. I changed the DHCP assignment from 192.168. 2.xxx, changed Gateway and DNS, and internet was working. I manually changed my computer configuration to 192.168. its own, and computers didn't know how to get through. 1.xxy IP with error that it couldn't connect to TV service, so looked like router was handing out different DHCP IP vs. I checked the TV box connected to the router, and it also had 192.168. This is odd because my internal network where I have medias, raspberryPi, and other devices directly connected runs on 192.168.1.1. I looked at the auto-IP configuration on my computer, and it picked up 192.168. When I went to the router web 192.168.2.1 (default), I saw that the no device was shown with DHCP lease, and in the logs, it said DHCP assignment had failed. I was connected directly to the router, and nothing worked. After the reset, and configuration, I could not connect to the internet. Of course, the DHCP tables were cleaned, because of the reset.
I had no issues until last week, where I decided to reset my router because of forgotten settings. My Speedport Smart 3 router upgraded to the new firmware 010137.4.6.001.2. Also, um Verwirrung zu vermeiden, werde ich in Englisch schreiben. Hallo, es tut mir leid, mein Deutsch ist nicht sehr gut.
0 kommentar(er)
